Heres the pic. of the reed block!

Just did a quick run up on the table!
Quiet pipe, homemade header, old big bore borgXwarner carby.
Getting 15,000 rpm repeatedly so far, need to make some mounts to hold it down and add a rod to the carby as it very hard to hold on to and operate the carb while its reving like that!
Will get a vid as soon as I get this all done!

Not bad Dude!!!!!!!!!

Ive hit a wall anyway!
I spoke to 'chip' and apparently 15,000 rpm is too much for these cranks, was told not to stand anywhere near it if reving this hard in case of crank failure.
13,500 is max you want to take one of these to.