Nice job! I like the finishing of the hull.
Trick strut and turnfin!

:drinks: Hi,
Thats a reeeeally nice job and the carbon bis are great.
Cya. Graeme:clapping:

Hi Len,
looks like its coming along nicely, bet you cant wait to get it on the water!, mikes glassing mine up in the next couple of weeks so my hi rev will have a home again:P , let us know how you get on :drinks:

Hi Damian,
yes getting there its taking forever with freight but hopefully i will get my parts tomorrow so i can get some GPS readings and see if the rear exhaust engine will be OK in same position as standard! this weekend:diablo:

i did some testing only to have a little engine drama :dash: so at the moment i am refitting with RMCK engine so when i have it sorted i will put in the thread also i will have the proper hardware frome mike so that it will even better thanks for looking:bye:

Man that is a BEAUTIFUL boat!

thanks darkphreak mike does a fantasic job he did the graphics as well glassen it up.
I could not have got better for my money hopfully this sunday i can give it a run

Hi everyone i did some playing my local pond that has started evapurating to small size due to summer here with a stock rcmk engine and was impressed with boats handling in competition on a tight course with only 10 meter turns it had no indication of flipping in rough water and with gps in competition it ran a average of 90kph on small course is a good start i used a couple of different props one being a voodoo 6719-3 with a balance and sharpening will be used on little bigger pond the prop i used best on small pond was a abc 2714-2 modded i will keep this motor in it and have orded a modded top end kit from bruce at Gizmo motors then it will be more fun and my rear exhaust engine will be going in my lakeracer rigger from mike cant wait
thanks for reading