Antron Brown's Twin Inline Warpath Rigger in the building...

Marc,
yes, that is the strut. Tha shaft I gave you is a short one. But there are also longer ones what might be better for the longer carbon strut. Just let me know if you need anything.
And be sure i want one of these twin riggers!

Yes it was me Marc. Just let me know when the kit is ready and will talk about. Have the motor ready to go. :whistle: :blink:

A few pics of the boat finished.


www.modelgasboats.com

Sent from my iPhone using Tapatalk.

Nice job Marc! Can't wait to see AB running this one, Really light! And u kno its going to get a nice paint job to match his others. Good job, see ya.

mtchbnntt wrote: Nice job Marc! Can't wait to see AB running this one, Really light! And u kno its going to get a nice paint job to match his others. Good job, see ya.

Thanks I'm looking forward to seeing it when it's all done up and running!

It did turn out pretty light, but let me say I built it very strong nonetheless. Been learning stuff as I build more and more of these riggers. The carbon for example makes the tub so stiff it's amazing. Ties in the side to the bottom too. The entire top sheeting is pinned. The transom is pinned and CF reinforced. Every single glue joint on the boat is West System Epoxy or T-88 structural epoxy. Takes a lot longer to build but in the end it makes for better boats.


www.modelgasboats.com

Sent from my iPhone using Tapatalk.